Force transducer, torque transducer, strain gauge amplifier
03 21 00 09 60
CONTACT
OK
Our company
About CAPTRONIC
Our locations
PRODUCTS
Load pins
Customized load pin sensors
Standard Load pins
Force Transducers
Force transducer_definition
Compression load cells
Tension & compression load cells
Tension load cell
Torque transducers
Rotary Torque transducers
Static torque transducers
Torque wrench bench
Mechanical coupling for torque transmission - torque limiter
Load limitation
Load schackle
Link load cells, dynamometer
Tensiometer
Tensile force measurement in cable or rope
Multi-axis sensors
Multiaxis load cell : 1 to 6 axis
Shift knob sensor
Brake pedal force sensor
Customized torque and force sensors
Customized sensor design
Flush diaphragm pressure transducer
Electronic & Software
Amplifiers & Conditioners
Display indicators
Load limitation
Digital output converter
Data logger for sensors
Programmer for miniature amplifier
Telemetry
Applications
Force and torque calibration
ISO-376 standard approach
Sensor calibration procedure
Our facilities
Stress Analysis- Strain gauge bonding
High temperature equipment
Force sensing screw & bolt
Our technical approach
Applications
Terminology - Definition
Jobs
Range of products
All Products
>
Transducers
>
Load monitoring
>
Tensile force measurement in cable or rope
Search
Your Cart
Tensile force measurement in cable or rope
Tensile strenght measurement in cable and rope with force sensor
How do you control the tensile force of a cable without direct insertion of a force sensor?
By means of a force transducer, the cable tension measurement is very often performed by an indirect measurement of the tension force of the wire or cable by performing a local displacement of the live wire / cable and observing the resultant force calculated and setup on the measuring device. The usual units displayed are : daN, ton, Lbs ...
CAPTRONIC also designs and manufactures steel wire devices with a diameter of less than one millimeter but also for cables up to 36 mm in diameter and tensile force which can reach 250KN.
CAPTRONIC: specific designed of force sensors or tensiometers
The device shown below is designed for cable tension monitoring of 500 daN, its dimensions allows an easy integration.
In this case the cable is not under motion, but the efforts can change while processing.
Welding wire tensile force measuring device (diameter less than 1mm)
Below is a picture of a part of a welding wire tension measuring device for use on an automatic pipe-flange welder.
This sensor makes it possible, during the course of the welding wire, to be able to continuously measure the
force during the welding process and thus to allow the control of the tensioner of the distribution coil.
Tensiometer for cable whose diameter range is 1mm to 36 mm :ponctual measurement
Below is a photo of a cable tension measuring device connected to a portable display and allows to measure the tension forces of a cable whose diameter varies from 1mm to 36mm . This device is intended for spot
measurements: cable-stayed structures, mooring cables, tensile structure reinforcements ...
